OCZ's RevoDrive Preview: An Affordable PCIe SSDby Anand Lal Shimpi on June 25, 2010 2:15 AM EST
A few weeks ago a very smart friend of mine sent me an email asking why we haven’t seen more PCIe SSDs by now. While you can make the argument for keeping SATA around as an interface with traditional hard drives, it ends up being a bottleneck when it comes to SSDs. The move to 6Gbps SATA should alleviate that bottleneck for a short period, but it is easy enough to put NAND in parallel that you could quickly saturate it as well. So why not a higher bandwidth interface like PCIe?
The primary reason appears to be cost. While PCIe can offer much more bandwidth than SATA, the amount of NAND you’d need to get there and the controllers necessary would be cost prohibitive. The unfortunate reality is that good SSDs launched at the worst possible time. The market would’ve been ripe in 2006 - 2007, but in the post recession period getting companies to spend even more money on PCs wasn’t very easy. A slower than expected SSD ramp put the brakes on a lot of development on exotic PCIe SSDs.
We have seen a turnaround however. At last year’s IDF Intel showed off a proof of concept PCIe SSD that could push 1 million IOPS. And with the consumer SSD market dominated by a few companies, the smaller players turned to building their own PCIe SSDs to go after the higher margin enterprise market. Enterprise customers had the budget and the desire to push even more bandwidth. Throw a handful of Indilinx controllers on a PCB, give it a good warranty and you had something you could sell to customers for over a thousand dollars.
OCZ was one of the most eager in this space. We first met their Z-Drive last year:
The PCIe x8 card was made up of four Indilinx barefoot controllers configured in RAID-0, delivering up to four times the performance of a single Indilinx SSD but on a single card. That single card would set you back anywhere between $900 - $3500 depending on capacity and configuration.
With the SSD controllers behind a LSI Logic RAID controller there was no way to get TRIM commands to the data. OCZ instead relied on idle garbage collection to keep Z-Drive owners happy. Even today the company is still working on bringing a TRIM driver to Z-Drive owners.
The Z-Drive apparently sold reasonably well. Well enough for OCZ to create a follow on drive: the Z-Drive R2. This card uses custom NAND cards that would allow users to upgrade their drive capacity down the line. The cards are SO-DIMMs populated with NAND, available only through OCZ. The new Z-Drive still carries the hefty price tag of the original.
Ryan Petersen, OCZ’s CEO, hopes to change that with a new PCIe SSD: the OCZ RevoDrive. Announced at Computex 2010, the RevoDrive uses SandForce controllers instead of the Indilinx controllers of the Z-Drives. The first incarnation uses two SandForce controllers in RAID-0 on a PCIe x4 card. As far as attacking price: how does $369 for 120GB sound? And it is of course bootable.
OCZ sent us the more expensive $699.99 240GB version but the sort of performance scaling we'll show here today should apply to the smaller, more affordable card as well. Below is a shot of our RevoDrive sample:
The genius isn’t in the product, but in how OCZ made it affordable. Looking at the RevoDrive you’ll see the two SandForce SF-1200 controllers that drive the NAND, but you’ll also see a Silicon Image RAID controller and a Pericom PI7C9X130 bridge chip.
The Silicon Image chip is a SiI3124 PCI-X to 4 port 3Gbps SATA controller. The controller supports up to four SATA devices, which means OCZ could make an even faster version of the RevoDrive with four SF-1200 controllers in RAID.
Astute readers will note that I said the Sil3124 chip is a PCI-X to SATA controller. The Pericom bridge converts PCI-X to a PCIe x4 interface which is what you see at the bottom of the card.
The Pericom PCI-X to PCIe Bridge
Why go from SATA to PCI-X then to PCIe? Cost. These Silicon Image PCI-X controllers are dirt cheap compared to native PCIe SATA controllers, and the Pericom bridge chip doesn’t add much either. Bottom line? OCZ is able to offer a single card at very little premium compared to a standalone drive. A standard OCZ Vertex 2 E 120GB (13% spare area instead of 22%) will set you back $349.99. A 120GB RevoDrive will sell for $369.99 ($389.99 MSRP), but deliver much higher performance thanks to you having two SF-1200 controllers in RAID on the card.
You’ll also notice that at $369.99 a 120GB RevoDrive is barely any more expensive than a single SF-1200 SSD, and it’s actually cheaper than two smaller capacity drives in RAID. If OCZ is actually able to deliver the RevoDrive at these prices then the market is going to have a brand new force to reckon with. Do you get a standard SATA SSD or pay a little more for a much faster PCIe SSD? I suspect that many will choose the latter, especially because unlike the Z-Drive the RevoDrive is stupidly fast in desktop workloads.
If you’re wondering how this is any different than a pair of SF-1200 based SSDs in RAID-0 using your motherboard’s RAID controller, it’s not. The OCZ RevoDrive will offer lower CPU utilization than an on-board software based RAID solution thanks to its Silicon Image RAID controller, but the advantage isn’t huge. The only reason you’d opt for this over a standard RAID setup is cost and to a lesser extent, simplicity.
What’s that Connector?
When I first published photos of the Revo a number of readers wondered what the little connector next to the Silicon Image RAID controller was. Those who guessed it was for expansion were right: it is.
Unfortunately that connector won’t be present on the final RevoDrive shipped for mass production. At some point we may see another version of the Revo with that connector. The idea is to be able to add a daughterboard with another pair of SF-1200 controllers and NAND to increase capacity and performance of the Revo down the line. Remember that Silicon Image controller has four native SATA ports stemming off of it, only two are currently in use.
Post Your CommentPlease log in or sign up to comment.
View All Comments
orangpelupa - Friday, June 25, 2010 - link"It'll offer up to twice the performance of a Vertex 2 SSD for only $20 more when it ships in July."
lol i read that wrong.
and though the SSD only priced @ $20 >_<
HollyDOL - Friday, June 25, 2010 - linkNice reading, thanks for another SSD review.
btw, on Installation and Early Issues you have a typo:
I headed into the Silicon Image BIOS, asked to recreate the array, specified the entire 233GB
should be 223GB ;-)
Rajinder Gill - Friday, June 25, 2010 - linkThanks for point that out, it's fixed.
TonyB - Friday, June 25, 2010 - linkwould have been nice to see this thing saturate the PCIe 4x bus on sequentials (1GB/s?). but alas we get a hardly faster if not equal device similar to the Crucial C300 on a sata3 channel.
i'll pass thanks.
Phate-13 - Friday, June 25, 2010 - linkRecently encountered a very interesting ssd, seems like crucial launched a new ssd, 64GB version. And at $150, it's a bargain for it's performance. It's not only cheaper then an Intel Postville per Gigabyte, it's also seems to be faster.
(Didn't know where else to put this tip.)
therealnickdanger - Friday, June 25, 2010 - linkWow, that is fantastic! I guess I never even thought to look for a smaller C300 model, but 64GB is really all that I need. @ $150, that's clearly the BEST deal around! Two of those in RAID-0 is $300 and would destroy the Revo or Z!
vol7ron - Friday, June 25, 2010 - linkYou must not read any articles here.
In order of occurrence (later to newer):
Phate-13 - Friday, June 25, 2010 - linkYou must only read the titles of the articles here.
1. The 64GB version is new, and a lot cheaper then the 128GB version. The 128GB costs more then double that of the 64GB.
2. If your not trying to point out that it is not new, but the fact that there are problems with it, read the last article:
"The update should go live while I'm out of the country, but it looks like by the end of this month things should finally (hopefully?) be safe for C300 owners. "
It's been two months, so things should be ok by now.
So if you got some information about CURRENT affairs, that would be appreciated, and for the rest, that is interesting reading material for people who are interested in the ssd indeed, but for the rest, I know that already. The only thing I'm interested in right now if there still are those problems.
Qapa - Saturday, June 26, 2010 - linkHi Anand,
Can you give us an update indicating if everything is working fine by now or if there are still problems?
Of course, more problems can appear later on but just to know if, for now, it seems to be ok...
Trisagion - Friday, June 25, 2010 - linkCan anybody please tell me the <b><i>name</i></b> of that connector above the SI chip? I know it's an expansion slot for a daughter board, but what is it called? It's driving me crazy!